Welcome to Steroids.Reviews Forum!

Notifications
Clear all

Alternate Syno Conversion help  

Page 2 / 2
  RSS

quebola
(@quebola)
Active Member
Joined: 5 months ago
Posts: 5
16/04/2020 10:26 pm  

- 80cc Water
- 50cc Isopropyl Myristate
- 110cc 95% Ethanol or 99% Isopropyl Alcohol

would that work for the powder? and calculate approx 42mg/ml
(i got that off of a finasol making article)


ReplyQuote
AssItch
(@assitch)
New Member
Joined: 5 months ago
Posts: 3
16/04/2020 11:18 pm  

The oleic acid and DMSO are the strongest penetrants in there. Unfortunately DMSO smells the worst, too. Hence the d-limonene (which I think also has some emulsifying properties).

The Iso has SOME penetrating properties, but not much. Main reason to have it in there is dissolving the powder.


ReplyQuote
quebola
(@quebola)
Active Member
Joined: 5 months ago
Posts: 5
16/04/2020 11:58 pm  

i added the saturated lye to the original heet+syno mix. i checked on it about 3 hours laters and it had turned into a thick yellow gelatenous mass, is this normal!?


ReplyQuote
razor27
(@razor27)
Active Member
Joined: 2 years ago
Posts: 12
17/04/2020 12:42 am  

i think so,when i do syno conv to make test prop it becomes white gelatenous mass,but i heard that the tne procedure turns yellow i think but wait and see what other people say.


ReplyQuote
Pharmhand
(@pharmhand)
Active Member
Joined: 5 months ago
Posts: 5
17/04/2020 1:15 am  

Yes, Turns Yellow....that will rinse off. I used two gal of distilled h2o
Product comes out white pwdery stuff....not quite as fluffy as T-Prop but still very white, very loose (once clumps are broken up) Easily goes into an oil solution with about 0.5%BA.
Just a tip for your final product....if you were thinking of injecting it as a suspension....go with oil, not water. I am having a bitch of a time keeping my aqueous Suspension from falling out, however, the batch I did with oil is crystal....clean...clear. The oils suspension is simply sunflower oil w/0.5%BA to disinfect and preserve. Baked 2x for 2hrs at 225F then steamed the fuck out of it in a rice cooker for 30minutes. The mix seems to be holding 150mg/ml with no fall out. Did a test shot....the injection itself was painless but I got that 12hr delayed pain very similar to Prop injects. the only difference was it only lasted about a day whereas pain from a prop shot can linger for a few days with me. The androgen kick was crazy....got a huge pump in the gym and blasted thru my workout.....kinda the way D-bol gets you fired up. Libido is thru the roof.
IMO Go with an oil suspension for your TNE. The Aqueous suspension is difficult to maintain and also hurts a fuck of alot more. I noticed little difference in the onset time or duration. When I go on this stuff for my next cycle, I plan on 2x day 50mg (approx 1/2cc) site injects.......I only plan on using the Suspension for maybe two weeks until my cyp kicks in. 2X ED injects can get real old real quick. Might keep some of this stuff around for the bedroom.....'bout 3-4 hrs before and she's calling me her 'Daddy'! Fuckin stuff kicks...I'd be scared to throw some cailis into the mix, she might never walk right again.


ReplyQuote
razor27
(@razor27)
Active Member
Joined: 2 years ago
Posts: 12
17/04/2020 1:49 am  

lol...is i that good i 've never used tne suspension .


ReplyQuote
razor27
(@razor27)
Active Member
Joined: 2 years ago
Posts: 12
17/04/2020 2:26 am  

how much test are you supposed to have after your done converting 5carts of syno...is it 8g...


ReplyQuote
Pharmhand
(@pharmhand)
Active Member
Joined: 5 months ago
Posts: 5
17/04/2020 3:06 am  

Perfect conversion can get you about 9 & 1/2 gms from 5 carts (2oomg each dose, 10 dose per cart, 2grm per cart). You're 8gram figure is a good ballpark number if you can't wiegh it out. Now in the REAL WORLD I got 17.6 gms from a 10 cart NaOH conversion. Good technique but I was not overly careful.
I bought a decent electronic gram scale for $60.....I'ts a must have.


ReplyQuote
razor27
(@razor27)
Active Member
Joined: 2 years ago
Posts: 12
17/04/2020 3:37 am  

cool thanks ,how would you rate test suspension .is it as good as everyone says.i like syno test prop.


ReplyQuote
Dallashunk
(@dallashunk)
New Member
Joined: 5 months ago
Posts: 1
20/04/2020 10:28 am  

I would rate it as very good,fast acting,but you must inject ED.Mine was a little too painful ,so I added more oil,dropped it down to 75mg/ml and did 1&1/2 ml ED painless.


ReplyQuote
razor27
(@razor27)
Active Member
Joined: 2 years ago
Posts: 12
20/04/2020 11:15 am  

out of curiosity if tne is good has anyone ever made and know how to make ester less fina?would it work better ?


ReplyQuote
Page 2 / 2
Share: